Laminate your own hands is not difficult. But it is important to know some details about which will be said in the statement.
Instruction
Difficulty level: Easy
step 1
The laminate must lay in the room before laying for at least one day at room temperature. For styling, you will need: a substrate for laminate, saw or jigsaw, wedges, hammer, ruler and construction pencil. Stacking is possible on the surface, as the old parquet, linoleum, fiberboard, particle Board and other smooth surfaces. If there are irregularities of more than 3 mm (1 meter) should be eliminated. Otherwise your laminate will bounce. Remember that the basis for laminate flooring must be smooth, dry, clean.
2 step
The substrate placed opposite to the laminate and the edge of the substrate create more gluing stationery tape. Laying laminate start so that the light from the window fell parallel to the seams of the laminate. Otherwise, just the seams of the laminate will be very noticeable if you don't put the laminate under hiraba. In a pack with the laminate sheet statement there all is in detail painted and written.
3 step
Laying laminate start with 1 in the second row with two boards. Don't forget to install wedges, which provide a gap between the wall and the laminate. They can be made from laminate. The laminate is placed a lock on itself for easy lock panels. After you have collected 1st row, cut a piece of laminate after the first set, lies at the beginning of the second row, believe me this is called waste of builders.
step 4
You need to proceed to the 2nd row. To cut part of the laminate to wear a sheet and so collected to the end wall of the second row. And again do, just cut off a piece of this is the beginning of the third row. Panel of the second row is set to the first, which already lies to the panel at an angle of 45 degrees, insert the entire second row in the castle or not. This time the dock is better to make two. If the laminate is not buckled properly, even by the hammer. And this technology is presented Paul to the end.
No comments:
Post a Comment