How to do well

You don't want to pay for drilling scaini? You don't want to give money for the digging of the well, which will also be a lot of money”? If You want to save up to 30 thousand rubles, then the following method of drilling wells just for You. Moreover, the method is simple as ABC and will not require from You any skills driller.

Instruction

Difficulty level: Easy

step 1

Stock up on materials. To get started, buy a pipe. They should have a diameter of 5-7 inches, a length of 1.5-2 meters. You will need no more than 8 such tubes. At the ends of the pipes cut the threads and buy a sleeve, to be able to connect pieces of pipe to each other. You will also need a steel rod. Buy a few pieces of 2-2 .5 meters in length, 20-30 mm in diameter. The pieces of the rod should be threaded at the ends, and coupling sleeve. In addition, manufacture of the steel cone. In diameter it should be more of a pipe. It will weld a piece of pipe cut lengthwise slits. These cracks in consequence of the wind grid. Turned out to be a simple filter.

2 step

Type in the pipe. Pipe with holes and cone vivite using two United steel rods. Put them inside the pipe, they will run into the cone. With the help of someone from the family or loved ones and raise sharply lower rods inside the tube. From shock about the cone filter will “subuniverse” in the ground. When the filter zagubica on its threaded part of the wind-impregnated paint tow, screw coupling, and on it a new piece of pipe. If Prut who You beat, it was too short, also pick up it. Pipes should be scored to a depth of 3-6 meters.

3 step

Get to the water. Probabilis on grubina 3-6 meters, check whether You got to the aquifer. To do this, take a bucket of water and pour into the tube. If the water is not leaving, hammer pipe another meter. Again pour a bucket of water. You need to ensure that the water in the pipe went quickly, it is an indication that You probabilis until the middle of the aquifer. After driving pipe try to pull a steel rod. If its jammed, beat on it with a hammer, but not from above, but from the side, from above.

step 4

Check the water quality. Pulling rod, screw on well fitting with the pump. Pump 2-3 buckets of muddy water, then the water is usually clean. But better not to risk and to pump out 200-300 liters. Then type clean water and boil it. Try the taste. If the water is bad, then it after boiling will become reddish or unclear, and at the bottom will drop out sediment. In this case, will deepen the well by another meter. It should be noted that such Skarina not able to give large amounts of water for a small amount of time due to the small diameter of the pipe, so You may have to make several such wells.